PEARL RECTIFIED PORCELAIN TILE

GENERAL DESCRIPTION
Pearl Porcelain Tile is a marble-effect porcelain tile and forms part of our Marble Sense. This tile is offered with a Polished Fully Lappato finish and is available in 6 different faces.

SPECIFICATION
Size Option(inch) : 12”x24” | 24”x24” | 24”x48”
Size Option(cm) : 30cmx60cm | 60cmx60cm | 60cmx120cm
Surface : Full Lappato | Polished
Thickness : 8.5 mm
Finish : Rectified
Inkjet : Yes
Nuans : V3 Slight
*Frost Resistance : Yes
**PEI : 4
***R Rating : R10

*Surfaces for All Purposes Inc. shouldn’t be held responsible for the installation of this product. A proffesional installation is recomended.

**This is an indication of the friction or abrasion resistance of the tile finishing surface.

PEI 3: For light traffic. Residental floor protected against abrasive agents such as sand, gravel and soil.

PEI 4: For medium traffic. Residential or light commercial floor protected against abrasive agents such as sand, gravel and soil. Example: Residential kitchen, office, boutiques.

PEI 5: High traffic. Residential or commercial floor. Example: cafés, hotels, restaurants.

***The measurement method specified in DIN 51130 distinguishes among the following R Slipperiness Classes and provides indications as to where they may be used;

R10 : SHARED TOILETS AND SHOWERS,SMALL KITCHENS IN RESTAURANTS AND CAFES,GARAGES AND BASEMENTS.

R11 : FOOD PRODUCTION FACILITIES ; MID-SIZED KITCHENS IN RESTAURANTS AND CAFES, WORKING ENVIRONMENTS WHERE THERE IS A A LOT OF WATER AND SLUDGE, LABORATORIES, LAUNDRIES, HANGARS.

USAGE

• Bath Floors/walls
• Comm. Interior Floor
• Comm. Interior Walls
• Res. Interior Floors
• Res. Interior Walls
• Shower Floors
• Shower Walls

*Usage recommendation must be confirmed by your installer and depends on application, installation methods and general suitability. Surfaces for All Purposes Inc. assumes no liability from any installation and usage recommendations.

INSTALLATION
Get the most out of your Surfaces for All Purposes Inc. product by following these helpful instructions for installing floor tile. A Few Dos & Don’ts

• Tile may be installed over most structurally sound substrates if they are clean, smooth, dry and free of wax, soap scum and grease and other debris.
• Carefully read and follow all instructions and precautions on the adhesive or mortar package. Mix only enough to be used within 30 minutes.
• Since variation of shades is an inherent characteristic of ceramic tile, mix tiles from several cartons as you set, for a blended effect.
• Order extra material for cuts, spare tiles, and waste.
• If material is face taped, remove tape after installation.
• Be sure to calculate exact tile needed for your surface before installation.
• If you are short of material do not start installation until you have all the tile that blends. Additional shipments may not match the tile from previous shipment.
• If you do order additional tile for an older job be sure to match color lots before installation.

SURFACES FOR ALL PURPOSES INC. AND ITS AFFILIATES ARE NOT RESPONSIBLE FOR ANY CLAIMS AS A RESULT OF THESE SUGGESTIONS. YOU MUST USE A PROFESSIONAL MARBLE INSTALLER AND PREMIUM SETTING MATERIALS.